Numerical Simulation of Yielding Supports in the Form of Annular Tubes Under Static and Dynamic Loads
Abstract
The extreme natural and man-made impacts on buildings have become more frequent for the past time due to the explosion of condensed explosives or explosive combustion of gas-vapor or air-coal mixtures. These accidents involve large human and economic losses and their prevention methods are not always effective and reasonable. The aim of this paper is to study the method of enhancing the explosion safety of buildings by means of yielding supports. The paper presents numerical results on strength ad deformability of yielding supports in the form of annular tubes under static and dynamic loads. The effect from yielding supports is estimated taking into account three stages of deformation, namely elastic, elasto-plastic, and elasto-plastic with hardening. It is shown that the rigidity of yielding supports significantly affects their stress-strain state. With increasing rigidity of deformable elements, the dependency between load and deformation of yielding supports in elastic and plastic stages is linear. Significant reduction is observed in relation to the dynamic response and the deformation time increases with the increase of the plastic component. Thus, it is possible to apply them as supporting units for reinforced concrete bending structures.
About the Authors
Oleg G. Kumpyak
Tomsk State University of Architecture and Building
Russian Federation
Russian Federation
Nikita V. Meshcheulov
Tomsk State University of Architecture and Building
Russian Federation
Russian Federation
References
1. Kumpyak O.G., Meshcheulov N.V. Prochnost' szhato-izgibaemykh zhelezobetonnykh konstruktsii po naklonnym secheniyam na podatlivykh oporakh pri dinamicheskom nagruzhenii [Oblique-section compressive and flexural strength of yield-supported concrete structures under dynamic load]. Vestnik of Tomsk State University of Architecture and Building. 2014. No. 6. Pp. 70–80. (rus)
2. Poonaya S., Thinvongpituk C., Teeboonma U. An Analysis of collapse mechanism of thin-walled circular tubes subjected to bending. Proceedings of WASET. 2007. No. 26. Pp. 329–334.
3. Mata P., Barbat A., Oller S., Boroschek R. Constitutive and geometric nonlinear models for the seismic analysis of RC structures with energy dissipators. Arch. Comput. Methods Eng. 2008. No. 15. Pp. 489–539.
4. Olabi A., Morris E., Hashmi M. Metallic tube type energy absorbers: A synopsis. Journal of Thin-Walled Structures. 2008. No. 45. Pp. 706–726.
5. Marzbanrad J., Mehdikhanlo M., Saeedi Pour A. An energy absorption comparison of square, circular, and elliptic steel and aluminum tubes under impact loading. Turkish J. Eng. Env. Sci. 2009. No. 33. Pp. 159–166.
6. Kumpyak O.G., Galyautdinov Z.R., Kokorin D.N. Strength of concrete structures under dynamic loading. Proc. 2nd All-Rus. Sci. Conf. of Young Scientists ‘Advanced Materials in Technology and Construction’. 2015. No. 1698.
7. Chiaia B., Kumpyak O.G., Placidi L., Maksimov V.B. Experimental analysis and modeling of two-way reinforced concrete slabs over different kinds of yielding supports under short-term dynamic loading. Engineering Structures. 2015. No. 96. Pp. 88–99.
8. Rastorguev V.S. Primenenie dinamicheskikh gasitelei kolebanii pri vzryvnykh vozdeistviyakh [Application of dynamic vibration dampers under explosive loads]. Stroitel'naya mekhanika i raschet sooruzhenii. 2009. No. 1. Pp. 50–57. (rus)
9. Kumpyak O.G., Galyautdinov Z.R., Kokorin D.N. Prochnost' i deformativnost' zhelezobetonnykh konstruktsii na podatlivykh oporakh pri kratkovremennom dinamicheskom nagruzhenii [Strength and deformability of reinforced concrete structures on yielding supports under dynamic load]. Tomsk: TSUAB Publ., 2016. Pp. 149–246. (rus)
10. Kumpyak O.G., Meshcheulov N.V. Deformability of oblique section of RC beams on yielding supports under dynamic impact. Proc. 4th Int. Sci. Conf. ‘Youth, Science, Solutions: Ideas and Prospects’. 2017. No. 1800.
Review
For citations:
Kumpyak O.G., Meshcheulov N.V. Numerical Simulation of Yielding Supports in the Form of Annular Tubes Under Static and Dynamic Loads. Vestnik of Tomsk state university of architecture and building. 2017;(5):121-134. (In Russ.)
Views:
448
Email this article 