COMPUTER SIMULATION OF BEARING CAPACITY OF LIGHT-WEIGHT STEEL SLENDER SECTIONS OF DIFFERENT CONFIGURATION
Abstract
The paper presents the methods of detecting the bearing capacity of light-weight steel slender sections using computer simulation. Two different configurations of slender sections are described: the traditional C-type section and the modified type ATLANT section. The results obtained are compared and their sensitivity to different input parameters (thickness, altitude, etc.) is analyzed in this paper.
References
1. Golubev K.V., Fedotov K.A. Problemy ispol'zovaniya novykh tekhnologii maloetazhnogo domostroeniya [Advanced technologies of low-rising house-building]. PNRPU Urbanity Bulletin. 2003. No. 3. Pp. 23–30. (rus)
2. Kashevarova G.G., Burkov A.I., Kosykh P.A. Analiz vliyaniya legkikh stal'nykh tonkostennykh profilei na teplosoprotivlenie ograzhdayushchikh konstruktsii [The analysis of light-weight steel sections affected by thermal resistance of walls]. Stroit. mekh. i raschet sooruzhenii. 2014. No. 6. Pp. 62–68. (rus)
3. Kashevarova G.G., Kosykh P.A. Influence analysis of cold formed steel members on thermal characteristics of building envelopes. Applied Mechanics and Materials. 2014. V. 670–671. Pp. 466–473.
4. Kashevarova G.G., Kosykh P.A. Opredelenie nesushchei sposobnosti legkikh stal'nykh tonkostennykh konstruktsii na osnove komp'yuternogo modelirovaniya [Computer simulation of bearing capacity of light-weight steel structures]. International Journal for Computational Civil and Structural Engineering . 2014. No. 10. Pp. 85–92. (rus)
5. Gunalan S., Bandula-Heva D., Mahendran M. Cold-formed steel columns subject to local buckling at elevated temperatures. Proc. ‘Steel Innovations Conference’. Christchurch, New Zealand, 21–22 February 2013.
6. Eurocode 3: Design of steel structures. Pt. 1–1: General structural rules.
7. Posobie po proektirovaniyu stal'nykh konstruktsii [Steel structure manual]. (SNiP II-23–81*). (rus)
8. Schafer B.W., PekEoz T. Computational modeling of cold-formed steel: characterizing geometric imperfections and residual stresses. Journal of Constructional Steel Research, 1998. No. 47.
9. Rondal J., Dubina D., Ungureanu V. Imperfections and computational modelling of coldformed steel members.
10. Adler Yu.P., Markova E.V., Granovskii Yu.V. Planirovanie eksperimenta pri poiske optimal'nykh uslovii [Experimental search for optimum conditions]. Moscow : Nauka Publ., 1976. (rus)
Review
For citations:
Kosykh P.A. COMPUTER SIMULATION OF BEARING CAPACITY OF LIGHT-WEIGHT STEEL SLENDER SECTIONS OF DIFFERENT CONFIGURATION. Vestnik of Tomsk state university of architecture and building. 2015;(2):135-143. (In Russ.)
Views:
644
Email this article 