Stress-strain state of sandwiched coating and its node connections under static load
https://doi.org/10.31675/1607-1859-2021-23-3-118-128
Abstract
Today, the interest in wooden structures is being increased mainly because wood is an environmentally friendly material. In this regard, quite new wooden materials are developed between the 20th and 21st centuries. Improved are the methods for joining wooden elements and joints of structures. The paper presents the experimental studies of the sandwiched coating consisting of two frame work blocks, and nodal connections under the static load. It is shown that the stress distributes in the coating and on the surface of the nodal connections. The stresstrain curves are suggested for the nodal connections and structural elements of the coating.
About the Authors
S. V. DeordievRussian Federation
Sergey V. Deordiev, PhD, A/Professor
79, Svobodnyi Ave., 660041, Krasnoyarsk, Russia
M. Y. Belichenko
Russian Federation
Maxim Y. Belichenko, Research Assistant
79, Svobodnyi Ave., 660041, Krasnoyarsk, Russia
M. A. Krasiev
Russian Federation
Mikhail A. Krasiev, Assistant
79, Svobodnyi Ave., 660041, Krasnoyarsk, Russia
M. V. Butenko
Russian Federation
Maksim V. Butenko, Graduate Student
79, Svobodnyi Ave., 660041, Krasnoyarsk, Russia
References
1. Turkov A.V. Vzaimosvyaz' zadach dinamiki i statiki sploshnykh i sostavnykh derevyannykh konstruktsii [Correlation between dynamic and static problems for solid-web and composite wood structures. PhD Thesis]. Orel, 2008. 43 p. (rus)
2. Korobko V.I., Turkov A.V. Dinamicheskie i staticheskie issledovaniya dvukhproletnykh balok s uprugopodatlivym ukrupnitel'nym stykom nad srednei oporoi [Dynamic and static analysis of double-span beams with joint on site over centre support]. Stroitel'naya mekhanika i raschet sooruzhenii. 2007. No 4. Pp. 47–48. (rus)
3. Loskutova D.V. Chastotno-vremennoi analiz derevyannoi fermy s soedineniyami na MZP [Time-frequency analysis analysis of wooden girder]. In: Aktual'nye problemy sovremennogo stroitel'stva: sb. materialov 60-i Mezhdunarodnoi nauchno-tekhnicheskoi konferentsii (Proc. 60th Int. Sci. Conf. ‘Relevant Problems of Modern Construction). Saint-Petersburg, 2007. Pp. 114–118. (rus)
4. Varenik A.S. Ustoychivost' szhatykh elementov derevyannykh konstruktsiy. Avtoreferat [Stability of compressed elements of timber structures. PhD Abstract]. Saint-Petersburg, 1994. 22 р. (rus)
5. Pyatikrestovskii K.P. K voprosu o vybore modulei uprugosti pri raschete derevyannykh konstruktsii na prochnost', ustoichivost' i po deformatsiyam [Selection of Young modulus in strength, stability and deformation analysis of wood structures]. Stroitel'naya mekhanika i raschet sooruzhenii. 2002. No. 6. Pp. 73–79. (rus)
6. Zhadanov V.I. Eksperimentalno-teoreticheskie issledovaniya napryazhenno-deformirovannogo sostoyaniya krupnorazmernyh kleefanernyh plit pri poperechnom izgibe [Stress-strain state of large laminated panel under transverse bending]. Izvestiya vuzov. Stroitelstvo. 2003. No. 4. Рр. 108–112. (rus)
7. Turkov A.V., Zulfikarova T.V. Uchet podatlivosti soyedineniy pri raschete rebristo-kol'tsevogo kupola iz drevesiny [Deformation capacity of joints in calculating wooden ribbed-circular dome]. In: Sbornik nauchnykh trudov Tadzhikskogo PI. (Coll. Papers). Dushanbe, Irfon 1991. Pp. 35–37. (rus)
8. Deordiev S., Frolovskaia A., Krasiev M. Development and static testing of the 18x6 m SSUTTMBF spatial structural unit. IOP Conference Series: Earth and Environmental Science. 2018. 012018.
9. Deordiev S.V., Kopanitsa D.G., Tutatchikov R.S., Krasiev M.A. Vliyaniye skorosti odnoosnogo szhatiya na soprotivleniye "chistykh" obraztsov drevesiny sosny [Uniaxial compression effect on of "pure" pine wood resistance]. Stroitel'stvo i rekonstruktsiya. 2017. No. 1 (69). Pp. 11–18. (rus)
10. Deordiev S.V., Kopanitsa D.G., Kopanitsa G.D., Tutatchikov R.S. Eksperimental'nyye issledovaniya kleyedoshchatykh balok na poperechnyy izgib pri deystvii staticheskoy i kratkovremennoy dinamicheskoy nagruzki [Transverse bending tests of laminated beams under static and dynamic loads]. Vestnik of Tomsk State University of Architecture and Biulding. 2014. V. 44. No. 3. Pp. 96–111. (rus)
11. Inzhutov I.S., Dmitriev P.A., Deordiev S.V., Zakharyuta V.V. Analiz su-shchestvuyushchikh uzlov sopryazheniya prostranstvennykh konstruktsiy i razrabotka sborno-razbornogo uzlovogo elementa [Analysis of existing interfacing nodes of spatial structures and development of dismountable nodal element]. Vestnik MGSU. 2013. No. 3. Pp. 61–71. (rus)
12. Inzhutov I.S., Zhadanov V.I., Nikitin V.M. Issledovaniye napryazhennodeformirovannogo sostoyaniya krupnorazmernoy rebristoy plity s obshivkoy, prikleyennoy na chasti dliny konstruktsii [Stress-strain state of large dimensioned ribbed plate with sheathing glued on structure surface]. Izvestiya vuzov. Stroitel'stvo. 2008. No. 7. Pp. 4–10 (rus)
Review
For citations:
Deordiev S.V., Belichenko M.Y., Krasiev M.A., Butenko M.V. Stress-strain state of sandwiched coating and its node connections under static load. Vestnik Tomskogo gosudarstvennogo arkhitekturno-stroitel'nogo universiteta. JOURNAL of Construction and Architecture. 2021;23(3):118-128. (In Russ.) https://doi.org/10.31675/1607-1859-2021-23-3-118-128