GAS-GYPSUM MATERIALS PROPERTIES MODIFIED BY PLASTICIZING AGENTS
https://doi.org/10.31675/1607-1859-2020-22-1-106-117
Abstract
The paper deals with porous gypsum building materials having heat-insulating properties and applied in low-rise building construction, in the manufacture of flat and room dividers.
Anhydrite of the Siberian Chemical Combine together with sodium carbonate is used as a gas-forming component. To regulate the plasticity of the mortar mixture, the Steinberg MP-4 and Steinberg PR-1S(A) superplasticizers are introduced into the composition, and their effect on the porous gypsum mixture properties is studied.
The analysis of the superplasticizer influence on the properties shows that the use of the Steinberg MP-4 with the amount of 2 wt.% of gypsum is optimum to achieve high strength of up to 27 MPa, while providing high mobility of the porous mixture. The main role of superplasticizers in a gypsum water-soluble composition is to increase the ξ-potential of the material and to reduce the water-gypsum ratio of the mixture while maintaining its mobility. The effect of superplasticizers largely depends on the initial modification of the binder, its dispersibility and mobility.
About the Authors
L. A. Anikanova
Tomsk State University of Architecture and Building
Russian Federation
Russian Federation
Ljubov' A. Anikanova, PhD, A/Professor
2, Solyanaya Sq., 634003, Tomsk
A. I. Kurmangalieva
Tomsk State University of Architecture and Building
Russian Federation
Russian Federation
Anna I. Kurmangalieva, Engineer
2, Solyanaya Sq., 634003, Tomsk
O. V. Volkova
Tomsk State University of Architecture and Building
Russian Federation
Russian Federation
Ol'ga V. Volkova, PhD, A/Professor
2, Solyanaya Sq., 634003, Tomsk
D. M. Pervushina
Tomsk State University of Architecture and Building
Russian Federation
Russian Federation
Dar'ya M. Pervushina, Student
2, Solyanaya Sq., 634003, Tomsk
References
1. Chernyshov E.M., Potamoshneva N.D., Monastyrev P.V., Yartsev V.P. Stroitel'no-tekhnologicheskaya utilizatsiya tekhnogennykh otkhodov kak kompleksnaya sistemnaya ekologoekonomicheskaya problema razvitiya territorii i gradostroitel'stva [Industrial waste utilization as a complex environmental and economic problem of territorial and urban development]. Voprosy sovremennoi nauki i praktiki. 2016. No. 4 (62). Pp. 67–86. (rus)
2. Pukharenko Yu.V., Kharitonova T.V. Otsenka primeneniya karbonatnykh zapolnitelei v sostave sukhikh smesei dlya restavratsii [Carbonate aggregates in dry mixture compositions for restoration]. Vestnik grazhdanskikh inzhenerov. 2018. No. 4 (69). Pp. 121–125. (rus)
3. Kodzoev M.-B., Isachenko S., Kosarev S., Basova A., Skvortzov A., Asamatdinov M., Zhukov A. Modified gypsum binder. MATEC Web of Conferences. 2017. Pp. 1–7. DOI: 10.1051/matecconf/201817003022
4. Lesovik V.S., Chernyshova N.V., Klimenko V.G. Protsessy strukturoobrazovaniya gipsosoderzhashchikh kompozitov s uchetom genezisa syr'ya [Structure formation of gypsumbased composites given the raw material genesis]. Izvestiya vuzov. Stroitel'stvo. 2012. No. 4. Pp. 3–11. (rus)
5. Ponomarenko A.A., Ponomarenko A.A., Kapustin F.L. Tehnologija pererabotki ftorangidrita dlja ispol'zovanija v proizvodstve portlandcementa. [Anhydrite processing technology in Portland cement manufacture]. Himicheskaja tehnologija. 2011. No. 6. Pp. 323–325. (rus)
6. Fedorchuk Yu.M. Tekhnogennyi angidrit, ego svoistva, primenenie. [Industrial anhydrite, its properties and application]. Tomsk: TPU, 2005. 110 p. (rus)
7. Garkavi M.S., Artamonov A.V., Kolodina E.V., Nefed‟ev A.P., Godovikov E.A., Buryanov A.F., Fischer H.-B. Aktivirovannye napolniteli dlya gipsovykh i angidritovykh smesei [Activated fillers for gypsum and anhydrite mixtures]. Stroitel'nye materialy. 2018. No. 8. Pp. 14–17. (rus) DOI: 10.31659/0585-430X-2018-762-8-14-17
8. Guerra-Cossio M.A., González-Lopez J.R., Magallanes-Rivera R.X., Zaldivar-Cadena A.A., Figueroa-Torres M.Z. Calcium sulfate: an alternative for environmentally friendly construction. Proc. 2nd Int. Conf. on Bio-Based Building Materials. 2017. Pp. 1–5.
9. Tayibi H., Choura M., López F.A., Alguacil F.J., López-Delgado A. Environmental impact and management of phosphogypsum. Journal of Environmental Management. 2009. No. 90 (8). Pp. 2377–2386.
10. Leonid D., Nataliya L., Mohammed S. Application areas of phosphogypsum in production of mineral binders and composites based on them: A review of research results. MATEC Web of Conferences. 2018. Pp. 01012.
11. Kudyakov A.I., Anikanova, L.A, Redlikh V.V., Sarkisov Yu.S. Vliyanie sul'fata i sul'fita natriya na protsessy strukturoobrazovaniya ftorangidritovykh kompozitsii. [The effect of sulfate and sodium sulfite on structure formation of anhydrite compositions]. Stroitel'nye materialy. 2012. No. 10. Pp. 50–53. (rus)
12. Anikanova L.A., Kurmangalieva A.I., Volkova O.V., Fedorchuk Yu.M. Gazogipsovye materialy s ispol''zovaniem vtorichnogo syr''ya [Foamed gypsum materials with fluoride additive]. Vestnik Tomskogo gosudarstvennogo arkhitekturno-stroitel'nogo universiteta – Journal of Construction and Architecture. 2018. V. 20. No. 6. Pp. 126–137. (rus)
13. Jassim Muhsin Aliewi, Abdul Qader Nihad Noori, Arshad Nadhom M. Ali. Effect of adding industrial wastes on the mechanical properties of gypsum. International Journal of Science and Research. 2019. No. 8. Pp. 2123–2125. DOI: 10,21275 / ART2020736
14. Dominic Gazdic, Jana Mokra, Jan Hanacek. Influence of plasticizers on properties of anhydrite binder. Key Engineering Materials. 2018. Pp. 16–21. DOI: 10.4028/www.scientific.net/KEM.760.16
15. Belov V.V., Bur'janov A.F., Jakovlev G.I., Petropavlovskaja V.B., Fisher H.-B., Maeva I.S., Novichenkova T.B. Modifikacija struktury i svojstv stroitel'nyh kompozitov na osnove sul'fata kal'cija. [Modification of structure and properties of construction composites based on calcium sulphate]. Moscow: De Nova, 2012. 196 p. (rus)
16. Peng J., Zhang J., Bai L., Li Q. Hydration and hardening characteristics of anhydrite binder modified with slag. Journal of Tongji University. 2009. Рp. 32–39.
17. Petropavlovskaya V.B. Ispol'zovanie mineral'nykh ul'tradispersnykh modifikatorov na osnove otkhodov promyshlennosti v gipsovykh kompozitakh [Mineral ultrafine modifiers based on industrial waste in gypsum composites]. Stroitel'nye materialy. 2018. No 8. Pp. 18–24. (rus)
18. Ustinova Yu.V., Sivkov S.P., Barinova O.P., Sanzharovskii A.Yu. Vliyanie razlichnykh dobavok na morfologiyu kristallov dvuvodnogo gipsa [Influence of various additives on crystal morphology of calcium sulfate dihydrate]. Vestnik MSBU. 2012. No. 4. Pp. 140–144. (rus)
19. Anikanova L.A., Volkova O.V., Kudyakov A.I., Kurmangalieva A.I. Mechanically activated composite fluoroanhydrite binder. Stroitel'nye materialy. 2019. No. 1–2. Pp. 36–42. DOI: 10.31659/0585-430X-2019-767-1-2-36-42. (rus)
20. Klimenko V.G. The role of a+, K+, Ca+, NH4+ sulfates based double salts in derivation of anhydrite binders. Vestnik BSTU. 2017. No. 12. Pp. 119–124. DOI: 10.12737/article_5a27 cb84ae0049.79523605
21. Lei Yang, Min Jing, Lingchao Lu, Xiantao Song, Xiaobin Dong. Properties and micro-structures assessment of building materials based on flue gas desulfurization gypsum modified by cement and industrial waste. Ceramics-Silikaty. 2019. Pp. 1–12. DOI: 10.13168 cs.2019.0009
Review
For citations:
Anikanova L.A., Kurmangalieva A.I., Volkova O.V., Pervushina D.M. GAS-GYPSUM MATERIALS PROPERTIES MODIFIED BY PLASTICIZING AGENTS. Vestnik Tomskogo gosudarstvennogo arkhitekturno-stroitel'nogo universiteta. JOURNAL of Construction and Architecture. 2020;22(1):106-117. (In Russ.) https://doi.org/10.31675/1607-1859-2020-22-1-106-117
Views:
850
Email this article 